Configuring Customer Order Picking Parameters
Use the Transaction Set Maintenance form to configure parameters for the Customer Order Picking mobile scanner transaction.
- Open the Transaction Set Maintenance form.
- Select CustOrdPicking from the grid.
-
Specify this information:
- Fill Warehouse
- Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.
- Successful Message
- Select this check box to show a success message when the transaction is successfully completed.
-
On the
Transaction Parameters tab,
in the
Parameter and
Value columns, configure
these parameters:
- Allow CSI Auto Reserved Lines To Pick
- If this check box is selected, users can pick both reserved and non-reserved customer order lines. If this is cleared, users can pick only the non-reserved customer order lines.
- Allow Overpick
- Select this check box to allow users to pick a greater quantity than the required quantity.
- Loc Recommend(Rank,leastInv,leastPick)
- Specify how to sort recommended picking locations:
- Rank: highest ranked locations are shown first
- LeastInv: locations with the fewest items are shown first, so they will be emptied first
- LeastPick: locations with the most items are shown first, allowing the picker to pick from fewer locations
- Negative Inventory Allowed
- This parameter defines if the factory track user is allowed to perform inventory transactions to drive inventory negative. If the Allow negative inventory parameter is selected in the global parameter form, then only this feature checks the Syteline parameter. If both Allow negative inventory and Negative Inventory Allowed are selected, then the factory track user must be allowed to perform such transactions across the modules/interfaces.
- Prefill Lot
- Select this parameter to allow users to select lots from the location options list.
- Stage Location
- Specify a default staging location.
- Optionally, on the Transaction Parameters tab, select Label Print Parameters to configure label printing parameters for this transaction.
- Click Save.