Configuring Cycle Count Parameters

Use the Transaction Set Maintenance form to configure parameters for the Cycle Count mobile scanner transaction.

  1. Open the Transaction Set Maintenance form.
  2. Select CycleCount from the grid.
  3. Specify this information:
    Fill Warehouse
    Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.
    Successful Message
    Select this check box to show a success message when the transaction is successfully completed.
  4. On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:
    Input Item
    Select this check box to confirm the scanned item number.
    Input Lot
    Select this check box to confirm the scanned lot number.
    Input Loc
    Select this check box to confirm the scanned location.
  5. Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
  6. Click Save.