Configuring End Just-In-Time Parameters

Use the Transaction Set Maintenance form to configure parameters for the End Just-In-Time Production transaction.

Open the Transaction Set Maintenance form.
Select End Just-In-Time from the grid.
Specify this information:

Fill Warehouse

Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

Successful Message

Select this check box to show a success message when the transaction is successfully completed.
On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

Allow Cross-Docking

Select this check box to allow cross docking from this transaction.

Default Container

To use a container by default, specify Y.

Kanban Auto Delivery Group

Putaway

Select this check box to allow users to perform put away transactions from within this transaction.

Receiving Location

Specify a default receiving location where the material is received.
Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
Click Save.