Configuring Work Center Material Issue Parameters

Use the Transaction Set Maintenance form to configure parameters for the Work Center Material Issue mobile scanner transaction.

  1. Open the Transaction Set Maintenance form.
  2. Select WorkCenterMaterial from the grid.
  3. Specify this information:
    Fill Warehouse
    Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.
    Successful Message
    Select this check box to show a success message when the transaction is successfully completed.
  4. On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:
    Enter UOM
    Select this check box to allow users to specify the unit of measure.
    Enter Employee
    Select this check box to allow a user to specify an employee ID. Clear this check box to always use the employee ID that is currently logged in.
    Allow Negative Inventory
    Select this check box to allow users to issue a quantity greater than the available quantity. If your ERP system is not configured to allow negative inventory, this parameter has no effect.
    Note: If the check box is selected, the logic must check the Syteline parameter.
  5. Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
  6. Click Save.