Configuring Start Project Labor and End Project Labor Parameters

Use the Transaction Set Maintenance form to configure parameters for the Start Project Labor and End Project Labor transactions.

Open the Transaction Set Maintenance form.
Select SF_ProjectLabor from the grid.
Specify this information:

Fill Warehouse

Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

Successful Message

Select this check box to show a success message when the transaction is successfully completed.
On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

Allow Pay Rate Entry

Select this check box to allow users to specify a pay rate.

Discrete Transaction

Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.
Click Save.