Configuring End Just-In-Time Parameters

Use the Transaction Set Maintenance form to configure parameters for the End Just-In-Time Production transaction.

  1. Open the Transaction Set Maintenance form.
  2. Select End Just-In-Time from the grid.
  3. Specify this information:
    Fill Warehouse
    Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.
    Successful Message
    Select this check box to show a success message when the transaction is successfully completed.
  4. On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:
    Allow Cross-Docking
    Select this check box to allow cross docking from this transaction.
    Default Container
    To use a container by default, specify Y.
    Kanban Auto Delivery Group
    Putaway
    Select this check box to allow users to perform put away transactions from within this transaction.
    Receiving Location
    Specify a default receiving location where the material is received.
  5. Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
  6. Click Save.