Configuring work center parameters

To configure parameters for the Work Center form:

  1. Select Configuration > Parameters > Transaction Set Maintenance. The Transaction Set Maintenance form is displayed.
  2. Select SF WorkCenter UI from the grid.
  3. Specify this information:
    Fill Warehouse
    Select this check box to default the warehouse for this transaction. The warehouse assigned to the user is defaulted.
    Successful Message
    Select this check box to display a message when the transaction is completed successfully.
  4. Configure these parameters on the Transaction Parameters tab, in the Parameter and Value columns:
    Work Center Popup Enabled
    Select this check box to open a separate form when users perform an action, such as Add Run or Start Indirect, allowing users to complete the action on the newly opened form. For example, if you select an operation and click Add Run, the Workset Maintenance form is opened, allowing the user to add the operation to the workset using the form. Clear this check box to complete most actions listed in the Tasks section or Workset section directly from the Work Center form when users perform an action. For example, if you select an operation and click Add Run, the operation is immediately added to the workset without opening any additional forms.
    Discrete Transaction
    Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.
    Show Service Labor Tab
    Select this check box to display the Service Labor tab, allowing employees to report time to SRO jobs.
    Show Project Labor Tab
    Select this check box to display the Project Labor tab, allowing employees to report time to projects.
  5. Click Save.