Disposition MRR

Use this form to record the disposition of material that has been placed on a QC MRR. This form is accessed only from the QC MRR form.

Messages optionally display when you open the form:

If Check for Test Results is set to Alert-If Defined on the QC General Parameters form, a message is displayed if there are test results defined for this QC item.
If Check for Test Results is set to Required-If Defined and there is a test plan defined for this QC item, you cannot enter a disposition until test results are recorded for the receiver.
If Check for Test Results is set to Required-Always, you cannot enter a disposition until a test plan is defined for this item and test results are recorded for the receiver.

The Serial Tab is active only when this receiver is marked for tracking by serial number. When the tab is active, you must record the disposition for each serial number individually.