Assigning serial or lot numbers

  1. In the RF, initially, use the instructions for picking an order by wave.

    See Picking an order by wave

  2. After picking a serial product, scan the serial number and continue to step 3. If you are picking a lot product, go to step 4.
    Note: The serial product’s Control option may be set up in Product Warehouse Product Setup to assign the serial number at Sales Order Entry. In that scenario, you are not required to scan a serial product on a non-Direct Order (DO) transfer during picking and packing. If the transfer is a DO, you are required to enter the serial number, regardless of the Product Warehouse Product Setup setting.
  3. Rescan the serial number. You are required to scan the same serial number twice before you can continue.
  4. If a specific lot number is specified on the order, then scroll to the right to select the correct pallet.
    Note: For linear cut lot products, use the Available Lengths column to verify that the allocated lot contains a piece with the necessary length.
  5. If a location contains more than one lot, a Please Choose Item screen is displayed for you to select the picking pallet. Scroll through the list and make your selection.
  6. If the lot number was assigned when the order was created, and you selected a different lot, a Pick From Label screen is displayed.
  7. If you selected No in the previous step, the Try another location? question is displayed. You can select Yes to select the lot from a different location.
  8. Complete the order.