SA Table Code Value Setup - Device Location overview

System Administrator > Setup > Table Code Value

When you use the Credit Card Interface with CenPOS, use this page to define a device location type for a device that is used as a scanner or to capture a receipt signature. Associate the device location with a IP address.

Specify this information based on whether your Virtual Terminal Bridge access is provided through a single centralized bridge or individual standard bridge connections [configure only one]:

  • To use the Centralized Virtual Terminal Bridge, specify the device serial number in the Centralized Bridge Serial Number field. Repeat the setup for each device.

  • To use the Standard Virtual Terminal Bridge, in the field, Standard Bridge IP Address, associate that device with an IP address. Repeat the setup for each device.

Caution: 
You may currently be using Standard Virtual Terminal Bridge, and you intend to switch to Centralized Virtual Terminal Bridge. If so, you must set up the serial number for each device in the SA Table Code Value Setup-Device Location. When you complete that task, then specify the new value in the Centralized Bridge IP Address field in SA Administrator Options-Documents-Sales Orders-Approval Process-Credit Card Processing. Sign out and sign back in to the system to activate this setting.

See information about the CenPOS Virtual Terminal Bridge and the additional setup for multiple devices.

To associate a device with a customer service representative (CSR) that uses the device, specify the device location on the CSR's SA Operator Setup record.