Put away confirmation

The confirmation occurs when you, the RF operator, put the product in a location and record the transaction on the RF unit. Record this transaction in the Stock PutAway-Select Item screen.
  • During the put away task, the RF operator may select a serial item. Parameter 3607, Receive/PutAway Serial Scan Confirmation, controls whether a serial number is verified during the receiving and putting away tasks.

  • During the put away task, the RF operator may select a lot item. The lot number is visible in the RF Stock PutAway-Select Item screen, and on the PutAway-Confirmation screen. This Lot number field is beneficial if you allow multiple lots per Location or Pallet. For example, parameter 7506, Allow Multiple Lots Per Location/Pallet, is set to Yes. As you go through the lines in the Lot browse, the lot number is displayed above the line. If a lot is not relevant, the second description is displayed as usual.

After you select the product to put away and the location, the PutAway-Confirmation screen is displayed. On this screen, you can verify the product, location, and quantity that you are putting away.

If the TWL administrator has selected No for parameter 5752, Force Scan of Item During PA, the Item field is skipped on the RF unit. You are warned by the system logic if you specify a non-existent product or a different product than the one currently on the screen. The system logic accepts the actual product ID or the cross reference for the product.

If the location is a full-case primary location, then the quantity is displayed in case quantities. Pallet and case quantities can be expressed as decimals. If you pick from the dock, the amount of inventory on the dock that is assigned for picks is considered by the TWL system logic. The quantity is then segregated. You are notified of the quantity that can fit in the location according to the available location capacity. If the expected quantity does not fit in the location, then you receive a warning. You can ignore the warning or use the information to determine how much you can put in the location.

If the quantity you specify does not match the expected quantity, then you are asked to verify the quantity specified. If the expected quantity does not fit in the location based on specific parameters, then a warning is displayed on the RF unit. The specific parameters are parameters 5753, Non-Primary Space Check, and 5754, Primary Space Check. The quantity that fits in the location according to the location constraints is displayed.

If the system logic indicates you should put away a zero quantity, then you must correct the inventory record by the suggested put away quantity. The quantity in the put away location is updated by the zero quantity and the inventory record is updated.